COMPARISON OF DIMENSIONS, SHAPES AND POSITIONS CONTROL USING CMM AND 3D SCANNER |
|---|
| Kenan Varda, Almira Softić, Nermina Zaimović-Uzunović, Ernad Bešlagić |
- Abstract:
- In this paper, measurements on stainless steel AISI 304 workpiece using Coordinate measuring machine Carl Zeiss Contura G2 and 3D scanner RangeVision PRO are compared and analyzed. Dimensional control is conducted by measuring 11 faces and 9 cylinders. Length, diameter, cylindricity, flatness and parallelism are controlled for features of interest. Using Calypso software on CMM and GOM Inspect software for 3D scanned model are used for creating virtual measurement strategies and dimensional and GD&T control. Deviations of measuring results using both measuring systems are shown and conclusions and recommendations for dimensional control are listed in tables.
- Keywords:
- metrology; CMM; 3D scanning; inspection; measurement
- Download:
- IMEKO-TC11-2022-01.pdf
- DOI:
- 10.21014/tc11-2022.01
- Event details
- IMEKO TC:
- TC11
- Event name:
- Joint IMEKO TC11 & TC24 hybrid conference
- Title:
Measurement for a better life
- Place:
- Dubrovnik, CROATIA
- Time:
- 16 October 2022 - 20 October 2022